NEWS

Home > News

What are the precautions for processing precision hardware parts?

date：2023/08/18

There are many points to pay attention to when processing precision hardware parts, so today our chief engineer of Binsen Precision Hardware will share with you the precautions when processing precision hardware parts:
1. Check whether the moving part is filled with lubricating oil before mechanical work, then start and check whether the clutch and brake are normal, and run the machine idling for 1-3 minutes. Operation is strictly prohibited when the machine is faulty.
2. Maintain the correct posture at work and have sufficient energy to cope with the work. If you find that you are unwell, you should leave the job immediately and report to the leader. During operation, you must concentrate your thoughts, chat and cooperate with each other. The operator should not operate in a state of irritability and fatigue to avoid accidents and ensure safe operation. Before entering the work position, all employees check whether their clothing meets the job requirements. Slippers, high heels, and clothing that affect safety are not allowed. Those with long hair must wear a helmet.
Gold parts processing

3. Turn off the power when changing the mold for precision hardware parts processing, and then install and debug the mold after the punching department stops running. After installation and adjustment, move the flywheel by hand to test punch twice to check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the blank holder is in a reasonable position.
4. You must wait for all other personnel to leave the working area of the machine and remove the sundries on the workbench before starting the power supply to start the machine.
5. When the machine is working, it is forbidden to reach into the working area of the slide block, and it is strictly forbidden to pick and place the workpiece by hand. Standard tools must be used when picking and placing the workpiece in the die. If abnormal sound or malfunction of the machine is found, turn off the power switch for inspection immediately. After the machine is started, one person transports materials and operates the machine. Others are not allowed to press the electric building or pedal the foot switch board, let alone put their hands in the working area of the machine or touch the moving parts of the machine with their hands.
6. When leaving get off work, you should turn off the idle power and arrange the finished products, side materials and sundries on the post to ensure a clean and safe working environment.